The job leaves your computer and the printer does nothing. Most of the time this is a stuck queue, the wrong printer selected, or a connection the computer thinks is live and is not.
The Ricoh SC899 error is a controller software crash typically caused by a corrupted print job, bad font data, or an unhandled data format.…
Lexmark error 900.00 is a service RIP software exception caused by a crashed processor, usually triggered by a corrupt print job or…
The Epson E-01 error is a fatal hardware fault usually caused by a mechanical obstruction, paper jam, or blocked print carriage. Unplug the…
The HP 49.4C02 error is a firmware exception usually caused by a corrupt print job, driver incompatibility, or malformed network data. To…
An HP 49 service error is a firmware or software communication fault typically triggered by a corrupted print job sent from a connected…
Error 79 is a firmware crash usually caused by a corrupt print job stuck in the queue. Turn off the printer, disconnect the network cable,…
The Ricoh SC670 error is a startup communication failure between the controller board and the engine board. Resolve this by performing a…
A slow printer is usually caused by high print quality settings, a congested wireless network, or a corrupted print spooler. Change your…
To fix a printer stuck on paused, open the Windows print queue settings and select Resume Printing from the printer menu. If it pauses…
To fix an HP LaserJet that will not print, clear stuck jobs from the Windows print queue and restart the print spooler service. If the…
Check for orange alarm lights and specific error codes on the display, then verify that ink levels are sufficient and protective tape is…
An Epson EcoTank printing blank or faded pages usually has dried ink clogging the nozzles or trapped air inside the ink tubes after running…
Clear any stuck print jobs by restarting the Windows Print Spooler and deleting files in C:\Windows\System32\spool\PRINTERS. Next, perform…
To resolve a printer that is not printing, clear any stuck print jobs in the Windows Print Spooler and ensure the printer is set as your…